Brodit 513323 Datasheet download pdf (Page 2)

1. 2.

INSTALLATION INSTRUCTIONS

4.3.

Please read all of the instructions and look at the pictures before attaching the holder. Note: The charger unit is

fused internally with 2 A automotive re-settable thermal fuse, but if an external fuse is to be installed then connect

a 2 A fuse holder and fuse inline with the Red wire close to the power source. Route the cable from the holder

into the vehicle dashboard and secure the charger unit in place with the adhesive tape provided. Ensure the

charger unit is securely mounted behind the dashboard in a well ventilated area that does not get hot! Note: If you

are connecting a GPS/Data device to the holder please ensure the charger unit is located in a position within

easy reach of any GPS or charging adapters. Route the power cable from the charger unit to the power supply

source in the vehicle and connect as follows: 1. Connect the White wire to a Negative Ground connection of the

vehicle or the vehicle chassis. 2. Connect the Red wire to a 12/24 Volt power supply in the vehicle that is

controlled by the ignition switch of the vehicle. Attaching the holder: 1. Loosen the screw in the center of the

holder so you can remove the attaching plate on the back. 2. Screw the attaching plate into place with the

enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Screw a

few turns on the screw, just so the thread starts to pull. Pull the holder toward you and hold it slightly tensed, in

the same time tighten the screw until the holder is firmly in place, but still can be adjusted. 3. To place the device

in the holder: Place the lower part of the device in the holder, then press the device forwards and downwards so it

snaps into place in the holder. To remove the device from the holder: Press downwards on the upper part of the

device, in the same time pull the the device out and up from the holder. 4. The holder is in place.

2(2)

1 2

No comments

Brodit 513323 Datasheet Page 2